Hard Drive Software Problems and Solutions
If the drive CMOS settings are not correct, the drive will not boot up. Find the key
combinations to access your BIOS and check the settings to see if the drive has been
recognized. Select "Auto" from the main BIOS screen and after rebooting, the drive should
be detected automatically. Be sure to save the changes and then reboot the computer to see
if the drive works.
Computer Boots but with Many Errors or Hangs
The LBA or Logid Block Addressing settings may be set wrong when your computer have
many errors, and if your computer is an older model. LBA is a method used by older PCs
to support IDE hard disks larger than 504 megabytes.
Access your BIOS and check the LBA settings. If the LBA settings are not enabled, enter
the BIOS and enable your LBA.
Your Hard Drive may have an IRQ Conflict
The primary hard drive controller normally uses the IRQ or Interrupt Request Line of
number 14 and if you have a second drive, it may use number 15.You may install a new
device such as a modem that uses IRQ 14 by default and once installed, the may not
recognize the hard drive.
The solution here would be to change the IRQ setting of the new device you installed to
another IRQ. Check the manual that came with the new device for possible IRQ settings.
Your Hard Drive Device Drives Causing Problems
In Windows XP, Vista, and 7, you can view the device drivers in the Control Panel and
update them if needed. If you are not sure you have the latest device drivers, perform these
steps to update, especially if you operating system is Windows 7.
Click on Start, Control Panel, System, and the System Properties will appear. Then click on
Hardware, and Device Manager. Click on Disk Drives and then your Hard Drive. Click on
Driver and here you can Update the Device Driver. You also have the option of Rolling
back to the old driver should something go wrong.
0 comments:
Post a Comment